Latest activity

What's new New posts Latest activity

alldodge reacted to MikeSchinlaub's post in the thread Not so welcome anymore.... with Like.

It must depend on where you go in the forum. I mostly hang out in the restoration bit, because I don't know anything about engines. I...

Friday at 12:46 PM
R

REG123 replied to the thread 4.3 GL Starting issues..

Follow up. Thanks to those that replied. When I replaced the starter last year I used this video as a guide and wired in the same...

Friday at 12:40 PM
M

MikeSchinlaub replied to the thread Not so welcome anymore.....

It must depend on where you go in the forum. I mostly hang out in the restoration bit, because I don't know anything about engines. I...

Friday at 12:37 PM
P

prc03sx195 posted the thread Gas/water separator filter in Mercury MerCruiser Sterndrives & Engines.

How often should I be changing the filter. It has 48 hrs on it. Three yrs old. Am I good to leave it go? This is on a 4.3 v6...

Friday at 12:35 PM
BWR1953 reacted to jbcurt00's post in the thread 82 Starcraft MR 180 floor, slight refit and leaks with Like.

It's a process..... and better now than after the 1st outing w a bilge full of water

Friday at 12:27 PM
frustratedboater replied to the thread Not so welcome anymore.....

I'm just looking for info from time to time to bail me out. Isn't that the purpose of this platform?

Friday at 12:18 PM
Bondo replied to the thread Engine revs out once it hits 3000rpm.

Ayuh,....... Anything other than oil,....

Friday at 12:17 PM
nola mike replied to the thread Lesson learned.

Here ya go, this should be from your 1984 (also, 1983 is before 1984) Again, accusing everyone else of being wrong is my issue.
Friday at 12:15 PM
Lou C replied to the thread Water in Oil.

Merc makes an OEM kit, and Barr Marine makes an aftermarket kit, I have used Barr with good results on my OMC, which also had the one...

Friday at 12:03 PM
redneck joe replied to the thread 82 Starcraft MR 180 floor, slight refit and leaks.

Have I mentioned I'm getting too old for this s.... Nine more replaced and sealed. Trying a more methodical approach for testing...

Friday at 12:00 PM
JimS123 replied to the thread Lesson learned.

Your reference was for a V6, years 1983-93. I don't dispute what they recommended in later years because I never read a newer book...

Friday at 11:46 AM
S

Skybreeze replied to the thread Engine revs out once it hits 3000rpm.

I was thinking coupler but will check drive oil first. What should I be looking for in particular.

Friday at 11:36 AM
N

Nordin reacted to jerryjerry05's post in the thread Tillotson TC-5E float needle valve with Like.

Years ago the factory service dept. issued a service bulletin. They suggested/said "set the air screws out at 1 turn and leave it there"...

Friday at 11:27 AM
C

Cgarski1 posted the thread Mercury 7.5 not peeing in Mercury & Mariner Outboards.

Hello all, I have a 1973 mercury 7.5 hp that is not peeing water. I replaced the impeller, tested it with my drill to make sure it was...

Friday at 11:14 AM
roscoe replied to the thread Not so welcome anymore.....

Been feeling it too. Usually from a small handful of members that brag about their decades of experience, but they fail to offer any...

Friday at 11:10 AM

Show older items

Top

View All

View All

View All

View All

View All

View All

View All

View All

Boat Bimini Tops

Boat Covers

View All

View All

View All

View All

View All

View All

View All

Latest activity

Follow Us