I put a 6” wire brush on a 4” angle grinder. It’ll take the paint off no problem. But wear leather gloves as it works well in knuckles too. It also works the grinder so I don’t overdo it. I also have a larger angle grinder with an 8” wire brush, but that’s a bit overkill for what you are doing...
People have put a receiver on the front of vehicle for easier trailer parking. This would keep the rear tires at the top of the ramp. But sounds like your problem is short term.
I’ve used the True Mods 3/4” lights. Very inexpensive and bright. When I get around to repainting the boat trailer I will convert to them. Made this below the tailgate driving/3rd brake light with them.
Just bought some Pettit EZ top side one part eurathane. Painted the side bunk supports first (trailer and boat the same color) to see how it goes on as this is the first time messing with a boat. It went on very smooth and glossy and I’m impressed with how hard it cured. Note the bunks were off...
Did a quick google search. Apparently this manufacturer has a jack with an oil port. Don’t recall seeing any oil port on mine. I like the point about drilling drain holes.
Reviving a 16 yo thread. Figured there should be better ways out there. Removing the decals on my 1998 Sylvan. Got one side done yesterday. To remove the glue, acetone did nothing , mineral spirits did nothing. Gasoline did the best but a lot of rubbing. Haven’t tried anything else yet. The 3M...
IMO, a replacement should be the exact same length. Take all the plugs out and use a scale through the plug hole to measure the distance to the piston at TDC. Even if the plug wouldn’t hit, I would find a replacement that is the same length. Would a longer plug affect the flame profile? I don’t...
